Have a Question?

Digi Connect® Wi‑ME 9210

Intelligent Wi-Fi Module in RJ-45 Form Factor

  • Secure 802.11b/g/n connectivity
  • Industrial operating temperature
  • RJ-45 form factor compatible with Digi Connect ME
  • Support for Digi Embedded Linux and Digi NET+OS
How to Buy

The Digi Connect Wi-ME 9210 embedded system-on-module (SoM) enables secure wired and wireless networking. Built on Digi's powerful NS9210 ARM9 processor, these high-performance modules allow customers to implement next generation network-enabled products. Additionally, their RJ-45 form factor is pin compatible with other Digi Connect ME and Digi Connect ME 9210 modules.

Digi Connect Wi-ME 9210 modules feature the development and operational benefits of Digi Remote Manager. This secure, highly-scalable platform seamlessly ties enterprise applications and remote devices together.

These modules can provide future application-specific interface options through the programmable Flexible Interface Module (FIM), while keeping the main serial port or other key peripheral interfaces available. They are well-suited for more advanced core module applications by supporting up to ten shared GPIOs, external IRQs and an extended set of peripheral interface options.

Specifications Digi Connect Wi-ME® 9210
Processor Type 32-bit Digi NS9210 processor
Processor Speed 75 MHz
Cache 4k I/D Cache
Memory Base Population Support up to 8 MB NOR Flash
Support up to 16 MB SDRAM
Flexible Interface Modules (FIMs) 300 MHz DRPIC165X CPU
2k program/192 bytes data RAM
On-chip 256-bit AES Accelerator
Power Management Modes On-the-fly clock scaling
Low-power sleep modes
Configurable scaling/wake-up events
(EIRQ, UART, Ethernet, etc.)
Pins/Form Factor RJ-45 connector style with 20-pin micro pin header (Samtec FTS-110-01-F-DV-TR)
High-Speed TTL Serial Interface Full signal support
Hardware/Software flow control
GPIO 10 shared
Up to 3 external IRQ options
SPI Master data rate up to 16.7 Mbps
Slave data rate up to 7.5 Mbps
I2C v1.0 bus interface
7-bit and 10-bit address modes
Flexible Interface Support (FIM) UART, 1-Wire, USB device (low-speed), CAN BUS
Watchdog Timer (16-bit)
JTAG Interface Available on development modules only
On-Board Power Supervisor
Wave-Solderable Design No clean flux process
Dimensions (L x W x H) 1.445 in (36.7 mm) x 0.75 in (19.05 mm) x 0.735 in (18.67 mm)
Network Interface – Wireless LAN
Standard IEEE 802.11 b/g/n
Frequency 2.4 GHz
Data Rate Up to 65Mbps with automatic fallback
Modulation CCK (11/5 Mbps), DQPSK (2 Mbps), DBPSK (1 Mbps), OFDM (6, 9, 12, 18, 24, 48, 54 and 65 Mbps)
Typical Transmit Power +17dBm
Receive Sensitivity -69dBm @ 54 Mbps
Connector 1 x RP-SMA
WLAN Security
WEP (Wired Equivalent Privacy) 64/128-bit encrycption (RC4)
WPA/WPA2/802.11i 128-bit TKIP/CCMP (AES) encryption.
Enterprise mode (802.1X): LEAP (WEP only), PEAP, TTLS, TLS,
Pre-shared key mode (PSK/Personal).
Operating Temperature -40° C to +75° C (-40° F to +167° F) -40° C to +85° C (-40° F to +185° F) with external thermal pad*
Storage Temperature -50° C to +125° C (-58° F to +257° F)
Relative Humidity 5% to 90% (non-condensing)
Altitude 12,000 feet (3,658 meters)
Power Requirements (3.3VDC)
Maximum 450 mA (1.485 W)
Typical 346 mA (1.14 W)
UART and Ethernet activated
Idle 186 mA (613 mW)
/16 clock scaling, Ethernet activated
Sleep 34 mA (113 mW)
Wake-up on EIRQ, Ethernet PHY off
Regulatory Approvals
FCC Part 15 Class B, EN 55022 Class B
EN 61000-3-2 and EN 61000-3-3
ICES-003 Class B, VCCI Class II, AS 3548
FCC Part 15 Sub C Section 15.247
IC RSS-210 Issue 5 Section 6.2.2(o)
EN 300 328, EN 301 489-17
UL 60950-1, EN 60950 (EU)
CSA C22.2, No. 60950
EN 55024
Intentional Radiation
Product Warranty 3 years
•Module Feature
*Please see hardware reference manual for detailed information



Support Documentation

User Manuals

Reference Manuals

Tech Specs





Recently Viewed