Home/Support/Support Forum/ATND gets Response when Router AT is connected to Computer, no response when on breakboard

ATND gets Response when Router AT is connected to Computer, no response when on breakboard

0 votes
I have a Xbee2 in Coordinator AT which is connected to a computer, a Xbee2 in Router AT which is connected to a breadboard and powered by Arduino's +3.3V and GND rails.

Coordinator AT
Code:
atid 2001 atsl 40A74613 atdl 40B19213

Router AT
Code:
atid 2001 atsl 40B19213 atdl 40A74613

When I use Coolterm to send the command `ATND` from the Coordinator XBee, theres no response from the Router XBee. Connecting pin 13 of the Router Xbee to an LED causes the LED to light up, so I guess the Router Xbee is powered properly.

`ATND` on the Coordinator AT
Code:
atnd 0000 0013A200 40A74613 FFFE 00 00 C105 101E 00030000



However when I also connect the Router Xbee to the computer (so both Xbees are connected to the computer), `ATND` does get a response from the Router XBee.

`ATND` on the Router XBee
Code:
atnd 0000 0013A200 40A74613 FFFE 00 00 C105 101E 00030000 3626 0013A200 40B19213 FFFE 01 00 C105 101E 00030000

How can I troubleshoot this problem?
asked Feb 23, 2014 in IEEE 802.15.4 by nyxynyx New to the Community (0 points)
edited Feb 21, 2014 by nyxynyx

Please log in or register to answer this question.

1 Answer

0 votes
Try querying the AI parameter on the router.
answered May 7, 2014 by mvut Veteran of the Digi Community (11,350 points)
...