Home/Support/Support Forum/Digital Pass thru not working.

Digital Pass thru not working.

0 votes
D-I/O pins not raising/lowering

I am attempting to build a star (1 center, 2+ outer) network that passes digital and analog data over the xbee pins (from outer node to center - and eventually to my Arduino which works will with direct wiring). To simplify, i have reduced to 2 nodes.

When using DOUT/IN the UART connection is working (this tested fine) however i cannot seem to affect the I/O Pins. I have upgraded to current/same firmware, and reset to factory.

Inventory and config :


2 Sparkfun Breakouts (programed via Sparkfun FTDI)


XBEE series 1 (Not pro)
Node 1 configuration
    ATID=3141
    ATD0=3
    ATD1=3
    ATIR=0
    ATDL=3434
    ATDH=0
    ATSL=40A08277
    ATSH=13A200
    ATMY=5656
    ATEE=0
    ATCH=C
    ATDD=10000
    ATVR=10ED


Node 2 configuration
    ATID=3141
    ATD0=4
    ATD1=5
    ATIR=0
    ATDL=5656
    ATDH=0
    ATSL=409F6478
    ATSH=13A200
    ATMY=3434
    ATEE=0
    ATCH=C
    ATDD=10000
    ATVR=10ED
asked Jul 29, 2014 in IEEE 802.15.4 by ybotman New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You have not enabled either change detect or a sample rate on your Input module. This needs to be done for the input to sample and transmit.
answered Aug 4, 2014 by mvut Veteran of the Digi Community (11,354 points)
...