Home/Support/Support Forum/Cannot connect to network

Cannot connect to network

0 votes
I messed up the wiring on the Xbee wifi, now I cannot get it to connect to my local network. I tried to reflash the firmware, but got a bad bootloader message. I can however read the settings on the Xbee.

Thank you,

Michael Carey
asked Aug 29, 2014 in IEEE 802.15.4 by mickpc00 New to the Community (1 point)
recategorized Aug 31, 2014 by tuxembb

Please log in or register to answer this question.

2 Answers

0 votes
You can try putting it back on the digi prototype board. Otherwise it sounds like the unit might be damaged. I don't think you can change the bootloader without RMAing it.
answered Aug 30, 2014 by kjensen8 Veteran of the Digi Community (623 points)
0 votes
I finally got it working by using the recover utility, re flashing and resetting the my network.
answered Aug 31, 2014 by mickpc00 New to the Community (1 point)
...