Home/Support/Support Forum/XBee S2 communicating wireless (serial Port) with PIC18F4620

XBee S2 communicating wireless (serial Port) with PIC18F4620

0 votes
I have 2 Xbee S2(Zigbee) Modules. I have 1 Coordinator AT and 1 Router AT. I also have assigned and configured the coordinator address to the router and the routers address to the coordinator.

I have 2 Embedded system PIC's. I have them communicating "Wired" through the RX and TX ports.

I want to use the XBees to communicate them wireless through the serial port. I have 2 Xbee Explorer Regulated boards so there are 4 outputs.

GND, 5V, Din, Dout

I have hooked up each Xbee to 1 PIC board using Din to TX and Dout to RX.

I am not able to send or receive data. I tried an external power source as well and still nothing.
asked Feb 25, 2016 in RF Solutions and XBee by chuetouyang New to the Community (0 points)
recategorized Mar 2, 2016 by LeonidM

Please log in or register to answer this question.

1 Answer

0 votes
Swap the Tx and Rx lines.
answered Mar 7, 2016 by mvut Veteran of the Digi Community (11,392 points)
...