Home/Support/Support Forum/Error writing the following AT parameters

Error writing the following AT parameters

0 votes
I have the XC09-038PKC-RA XCite 900MHz modems, I am trying to simply change the baud rate to 38400, it is currently set to 19200. any time i try to write anything using X-CTU it gives me an error and says "Error writing the following AT parameters -WR: connection timeout"

I have not been able to write any settings except an "xbee recovery" and reload the firmware, however this does not seem to change its baudrate...

Pleas help!
asked Jul 27, 2017 in XCite by kf7oor New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try connecting to it via an RS232 cable with an RS232 port.
answered Jul 27, 2017 by mvut Veteran of the Digi Community (11,354 points)
...