Home/Support/Support Forum/Digital Output Source Problem BL2010
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Digital Output Source Problem BL2010

0 votes
I am attempting to use my BL2010 to source voltage on the Digital Outputs.

I have relocated R32 0-ohm to R34 as directed in the user's manual.



#undef OUTPUT_DRIVE
#define OUTPUT_DRIVE SOURCING

#memmap xmem

#class auto



main(){

brdInit();

digOut(0, 1);
digOut(1, 1);
digOut(2, 1);
digOut(3, 1);
digOut(4, 1);
digOut(5, 1);
digOut(6, 1);
digOut(7, 1); // <-- break point set here so the code doesn't exit.
}

When I use my voltmeter on J9 pins 0 through 6, they all measure 0v.
I have 24v applied to 'K' on the J2 header.
I was expecting to measure this 24 volts on my digital outputs.

What am I missing?
Thank you
asked Jul 19, 2018 in Rabbit by woopelderly New to the Community (9 points)
recategorized Jul 20, 2018 by LeonidM

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
It turns out my BL2010 was not populated with the necessary transistors and resistors to use the Digital Outputs as Source Outputs. I contacted support and they provided a schematic, which solved my problem.
answered Aug 1, 2018 by woopelderly New to the Community (9 points)
...