Home/Support/Support Forum/XCTU DB Cellular Signal Strength
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

XCTU DB Cellular Signal Strength

0 votes
I currently use the Digi Xbee Cellular 3G and configure it with XCTU.
This also works so far. I'm just not sure about the "DB Cellular signal Strength".
Is there a table with values from "good" to "bad"? Unfortunately I cannot interpret these values.

best regards,
Julian
asked Aug 1 in Digi Connect Cellular by juk New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
From the manual https://www.digi.com/resources/documentation/digidocs/PDFs/90001541.pdf


DB (Cellular Signal Strength)
Reads the absolute value of the current signal strength to the cell tower in dB. If DB is blank, the XBee
Cellular Modem has not received a signal strength from the cellular component.
DB only updates when the modem is registered with the celllular tower. It is updated periodically, and
not when read.
Parameter range
0x71 - 0x33 (-113 dBm to -51 dBm) [read-only]

So -51 would be the best signal.
answered Aug 6 by kurte New to the Community (29 points)
...